At a Glance｜ Other Products ｜SpecGuard

SpecGuard is a high-gloss, water-based polymeric protectant that boosts the appearance and stain resistance of concrete floors
SpecGuard uses cross-linking nanotechnology for deep penetration and adhesion, creating a tough, stain-resistant coating with UV absorbers that protect colored or dyed concrete from fading. It can be used alone or paired with a reactive sealer like SpecHard or LithSeal SC for a glossy, harder, chemically resistant finish.
Key Features & Benefits

24-hour stain protection against common stain-causing agents found in grocery stores, restaurants, and warehouses
High-gloss finish resistant to scuffs, scratches, and stains without buffing
UV absorbers prevent degradation of colored or dyed concrete
Works on steel-troweled, honed, polished, or highly polished concrete
Low odor, water-based, meets federal VOC requirements
Meets USDA standards for indirect food contact

Application Instructions

Ensure the surface is clean and free of cures, oil, dirt, grease, or debris
Apply with a pump-up sprayer with a 0.5 gpm spray tip to a small section at a time
Spread with a microfiber pad using firm pressure for a thin, even coating
Allow to dry tack-free for 20-60 minutes, then burnish with a high-speed burnisher
Repeat for up to three coats for maximum gloss
Allow 72 hours of dry time before testing stain resistance

Technical Data Summary

Coverage: Typically 500-1,000 sq ft per gallon, depending on concrete porosity and texture

Shelf Life: 1 year from manufacture date

Packaging
Available in 5-gallon pails (also offered in 55-gallon drums and 1-gallon jugs).
Supporting Documents
Safety Data Sheet (SDS)
Technical Data Sheet (TDS)
Brand:SpecChemSKU:SGUARD-5Tags:Cementitious Products and Liquids, Concrete Densifiers